Enable; Exit-Overflow-Interval - Dell PowerConnect 8024 Cli Reference Manual

Example
The following example sets a route preference value of 100 for intra OSPF in the router.
console(config)#ipv6 router ospf
console(config-rtr)#distance ospf intra 100

enable

Use the enable command in Router OSPFv3 Configuration mode to enable administrative
mode of OSPF in the router (active).
Syntax
enable
no enable
Default Configuration
Enabled is the default state.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables administrative mode of OSPF in the router (active).
console(config)#ipv6 router ospf
console(config-rtr)#enable

exit-overflow-interval

Use the exit-overflow-interval command in Router OSPFv3 Configuration mode to configure
the exit overflow interval for OSPF. It describes the number of seconds after entering Overflow
state that a router will wait before attempting to leave the Overflow State. This allows the router
to originate non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
seconds
exit-overflow-interval
798
OSPFv3 Commands