Ip Multicast - Dell PowerConnect 8024 Cli Reference Manual

source-address — The IP address of the multicast data source.
•
source-mask — The IP subnet mask of the multicast data source.
•
rpf-address — The IP address of the next hop towards the source.
•
preference — The cost of the route (Range: 1 - 255).
•
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
Usage Guidelines
There are no user guidelines for this command.
Example
console(config)#
console(config)#ip mroute 1.1.1.1 255.255.0.0 192.168.20.1 34

ip multicast

Use the ip multicast command in Global Configuration mode to set the administrative mode of
the IP multicast forwarder in the router to active. For multicast routing to become operational,
IGMP must be currently enabled. An error message is displayed on the CLI if multicast routing
is enabled while IGMP is disabled. However, the IP multicast mode configuration is stored in
the multicast configuration file and is automatically enabled once IGMP is enabled.
Syntax
ip multicast
no ip multicast
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Multicast Commands
707