Interface Tunnel - Dell PowerConnect 8024 Cli Reference Manual

Tunnel Interface Commands
This chapter explains the following commands:
•

interface tunnel

• show interfaces tunnel
• tunnel destination
• tunnel mode ipv6ip
• tunnel source
interface tunnel
Use the interface tunnel command in Global Configuration mode to enter the interface
configuration mode for a tunnel.
Syntax
interface tunnel tunnel-id
tunnel-id
no interface tunnel
tunnel-id — Tunnel identifier. (Range: 0–7)
•
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#
Tunnel Interface Commands
54
859