Ip Igmp Snooping Mrouter-Time-Out; Show Ip Igmp Snooping Groups - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to
respond to an IGMP Query.
Use immediate leave only where there is only one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
console(config-if-1/g1)#ip igmp snooping leave-time-out 60

ip igmp snooping mrouter-time-out

Use the ip igmp snooping mrouter-time-out command in Interface Configuration mode to
configure the mrouter-time-out. This command is used for setting the aging-out time after
Multicast router ports are automatically learned. To reset to the default mrouter-time-out, use
the no form of this command.
Syntax
time-out
ip igmp snooping mrouter-time-out
no ip igmp snooping mrouter-time-out
time-out — mrouter timeout in seconds for IGMP. (Range: 1–3600)
•
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the mrouter timeout to 200 seconds.
console(config-if-1/g1)#ip igmp snooping mrouter-time-out 200

show ip igmp snooping groups

Use the show ip igmp snooping groups command in User EXEC mode to display the Multicast
groups learned by IGMP snooping.
280
IGMP Snooping Commands