Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
Default Configuration
If the default VLAN is enabled, PVID is 1. Otherwise, PVID is =4095.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example configures PVID 234 for gigabitethernet port 1/0/2,
when the interface is in general mode.
Console(config)#
Console(config-if)#
Console(config-if)#
switchport general ingress-filtering disable
Use the switchport general ingress-filtering disable Interface Configuration
(Ethernet, Port-channel) mode command to disable port ingress filtering. Use
the no form of this command to restore the default configuration.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Example
The following example disables port ingress filtering on gigabitethernet port
1/0/1.
Console(config)#
Console(config-if)#
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\VLAN_ISCLI_Only.fm
interface gigabitethernet 1/0/2
switchport mode general
switchport general pvid
interface gigabitethernet
switchport mode general
234
1/0/1
VLAN Commands
507
Advertisement
Table of Contents
