Redistribute - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1

redistribute

Use the redistribute command in Router OSPF Configuration mode to configure OSPF
protocol to allow redistribution of routes from the specified source protocol/routers. Use the no
version of the command to disable redistribution from the selected source or to reset options to
their default values.
Syntax
redistribute {rip | static | connected} [metric
[subnets]
no redistribute {rip | static | connected} [metric
[subnets]
• rip — Specifies RIP as the source protocol.
• static — Specifies that the source is a static route.
connected — Specifies that the source is a directly connected route.
•
• metric — Specifies the metric to use when redistributing the route. (Range: 0–16777214)
• metric-type 1 — Type 1 external route.
• metric-type 2 — Type 2 external route.
tag — Value attached to each external route, which might be used to communicate
•
information between ASBRs. (Range: 0–4294967295)
• subnets — Specifies whether to redistribute the routes to subnets.
Default Configuration
0 is the tag integer default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
758
OSPF Commands
integer ] [metric-type {1 | 2}] [tag
integer
] [metric-type {1 | 2}] [tag
integer
]
integer
]