Syntax
lldp receive
no lldp receive
Default Configuration
The default lldp receive mode is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable the LLDP receive capability.
console(config-if-1/g3)#lldp receive
lldp timers
Use the lldp timers command in Global Configuration mode to set the timing parameters for
local data transmission on ports enabled for LLDP. To return any or all parameters to factory
default, use the no form of this command.
Syntax
lldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-delay]
no lldp timers [interval] [hold] [reinit]
transmit-interval — The interval in seconds at which to transmit local data LLDPDUs.
•
(Range: 5–32768 seconds)
hold-multiplier — Multiplier on the transmit interval used to set the TTL in local data
•
LLDPDUs. (Range: 2–10)
reinit-delay — The delay in seconds before re-initialization. (Range: 1–10 seconds)
•
Default Configuration
The default transmit interval is 30 seconds.
The default hold-multiplier is 4.
The default delay before re-initialization is 2 seconds.
357
LLDP Commands