Area Virtual-Link Transmit-Delay - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example configures a 500-second retransmit wait interval.
console(config-router)#area 10 virtual-link 192.168.2.2
retransmit-interval 500

area virtual-link transmit-delay

Use the area virtual-link transmit-delay command in Router OSPF Configuration mode to
configure the transmit delay for the OSPF virtual interface identified by the area ID and
neighbor ID. Use the no form of the command to return the transmit delay to the default value.
Syntax
area-id
area
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or decimal from
•
0–4294967295)
neighbor-id — Identifies the Router ID of the neighbor.
•
seconds — Number of seconds to increment the age of the LSA before sending, based on the
•
estimated time it takes to transmit from the interface. (Range: 0–3600)
Default Configuration
1 second is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 40-second transmit-delay interval.
console(config-router)#area 10 virtual-link 192.168.2.2 tranmit-
delay 40
740
OSPF Commands
neighbor-id
virtual-link
neighbor-id
virtual-link
seconds
transmit-delay
transmit-delay