Show Fiber-Ports Optical-Transceiver - Dell PowerConnect 8024 Cli Reference Manual

1/g4 Open
1/g5 Fiber -

show fiber-ports optical-transceiver

Use the show fiber-ports optical-transceiver command in Privileged EXEC mode to display the
optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [
interface — A valid Ethernet port. The full syntax is unit / port.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The show fiber ports command is only applicable to the SFP combo ports and XFP ports (not
the ports on the SFP+ plug-in module).
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port Temp
----------- ------
1/g3 w
1/g4 OK
1/g1 Copper
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
TX Fault - Transmitter fault
LOS - Loss of signal
128
-
interface
]
Voltage Current
------- -------
OK E
OK OK
13:32:08 23 July 2004
Output Input
Power Power
------ -----
OK OK
OK OK
PHY Diagnostics Commands
TX LOS
Fault
----- ---
OK OK
E OK
973