Advertisement
–
Incoming untagged frames are assigned to this VLAN.
–
Outgoing traffic in this VLAN on this port is sent untagged or tagged, depending on the
port tagged mode.
Example
The following example shows how to configure the PVID for g16, when the interface is in general
mode.
console(config)# interface ethernet g16
console(config-if)# switchport general pvid 234
switchport general ingress-filtering disable
The switchport general ingress-filtering disable Interface Configuration mode command disables
port ingress filtering. To enable ingress filtering on a port, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to disable port ingress filtering on g16.
console(config)# interface ethernet g16
console(config-if)# switchport general ingress-filtering disable
switchport general acceptable-frame-type tagged-only
The switchport general acceptable-frame-type tagged-only Interface Configuration mode
command discards untagged frames at ingress. To enable untagged frames at ingress, use the no
form of this command.
321
VLAN Commands
Advertisement
