Ip Rip Receive Version - Dell PowerConnect 8024 Cli Reference Manual

Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the RIP Version 2 Authentication Type and Key for VLAN 11.
console(config-if-vlan11)#ip rip authentication encrypt pass123 35

ip rip receive version

Use the ip rip receive version command in Interface Configuration mode to configure the
interface to allow RIP control packets of the specified version(s) to be received. Use the no form
of the command to return the version to the default value.
Syntax
ip rip receive version {rip1 | rip2 | both | none}
no ip rip receive version
• rip1 — Receive only RIP version 1 formatted packets.
• rip2 — Receive only RIP version 2 formatted packets.
• both — Receive packets from either format.
• none — Do not allow any RIP control packets to be received.
Default Configuration
Both is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example allows no RIP control packets to be received by VLAN 11.
console(config-if-vlan11)#ip rip receive version none
Routing Information Protocol Commands
851