Dhcp L2Relay (Interface Configuration); Dhcp L2Relay Circuit-Id - Dell PowerConnect 8024 Cli Reference Manual

dhcp l2relay (Interface Configuration)

Use the dhcp l2relay command to enable DHCP L2 Relay for an interface. Use the "no" form of
this command to disable DHCP L2 Relay for an interface.
Syntax
dhcp l2relay
no dhcp l2relay
Default Configuration
DHCP L2Relay is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet).
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g1)#dhcp l2relay

dhcp l2relay circuit-id

Use the dhcp l2relay circuit-id command to enable setting the DHCP Option 82 Circuit ID for
a VLAN. When enabled, the interface number is added as the Circuit ID in DHCP option 82.
Use the "no" form of this command to disable setting the DHCP Option 82 Circuit ID.
Syntax
vlan-range
dhcp l2relay circuit-id vlan
vlan-range
no dhcp l2relay circuit-id vlan
vlan-range - The list of VLAN IDs.
•
Default Configuration
Setting the DHCP Option 82 Circuit ID is disabled by default.
Command Mode
Global Configuration
208
DHCP Layer 2 Relay Commands