Ipv6 Route - Dell PowerConnect 8024 Cli Reference Manual

User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan5)#ipv6 pimdm hello-interval 500

ipv6 route

Use the ipv6 route command in Global Configuration mode to configure an IPv6 static route.
Syntax
ipv6 route
hop-address
no ipv6 route
id next-hop-address
}]
ipv6-prefix — Is the IPv6 network that is the destination of the static route.
•
prefix-length — Is the length of the IPv6 prefix — a decimal value (usually 0-64) that shows
•
how many of the high-order contiguous bits of the address comprise the prefix (the network
portion of the address). A slash mark must precede it.
• interface — Identifies direct static routes from point-to-point and broadcast interfaces, and
must be specified when using a link-local address as the next hop.
• tunnel or vlan — Is the tunnel or vlan interface to associate with the route.
next-hop-address — Is the IPv6 address of the next hop that can be used to reach the
•
specified network.
preference — Is a value the router uses to compare this route with routes from other route
•
sources that have the same destination. (Range: 1-255)
Default Configuration
1 is the default value for
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configure an IPv6 static route.
674
IPv6 Routing Commands
ipv6-prefix prefix-length
/
preference
[ ]
ipv6-prefix prefix-length
/
preference
[
preference
[Null | interface {tunnel
[Null | interface {tunnel
]
.
tunnel-id vlan-id
| vlan
tunnel-id vlan-
| vlan
next-
}]