Dell PowerConnect 8024 Cli Reference Manual page 48

Table 1-1. System Command Groups
Command Group
DHCP l2 Relay
DHCP Snooping
Dynamic ARP Inspection
Ethernet Configuration
GVRP
IGMP Snooping
IGMP Snooping Querier
IP Addressing
IPv6 ACL
IPv6 MLD Snooping
IPv6 MLD Snooping Querier
iSCSI Flow Acceleration
LACP
Link Dependency
LLDP
Port Monitor
QoS
RADIUS
Spanning Tree
TACACS+
VLAN
Voice VLAN
802.1X
48
Command Groups
(continued)
Description
Enables the Layer 2 DHCP Relay agent for an interface.
Configures DHCP snooping and whether an interface is trusted for
filtering.
Configures for rejection of invalid and malicious ARP packets.
Configures all port configuration options for example ports, storm
control, port speed and auto-negotiation.
Configures and displays GVRP configuration and information.
Configures IGMP snooping and displays IGMP configuration and IGMP
information.
Configures IGMP Snooping Querier and displays IGMP Snooping
Querier information.
Configures and manages IP addresses on the switch.
Configures and displays ACL information for IPv6.
Configures IPv6 MLD Snooping.
Configures IPv6 Snooping Querier and displays IPv6 Snooping Querier
information.
Configures special QoS treatment for traffic between iSCSI initiators
and target systems.
Configures and displays LACP information.
Configures and displays link dependency information.
Configures and displays LLDP information.
Monitors activity on specific target ports.
Configures and displays QoS information.
Configures and displays RADIUS information.
Configures and reports on Spanning Tree protocol.
Configures and displays TACACS+ information.
Configures VLANs and displays VLAN information.
Configures voice VLANs and displays voice VLAN information
Configures and displays commands related to 802.1X security protocol.