Dot1X Max-Req - Dell PowerConnect 8024 Cli Reference Manual

Syntax
dot1x mac-auth-bypass
no dot1x mac-auth-bypass
Default Configuration
MAC Authentication Bypass is disabled by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets MAC Authentication Bypass on interface 1/2:
console(config-if-1/g2)#dot1x mac-auth-bypass

dot1x max-req

Use the dot1x max-req command in Interface Configuration mode to set the maximum number
of times that the switch sends an Extensible Authentication Protocol (EAP)-request frame
(assuming that no response is received) to the client before restarting the authentication
process. To return to the default setting, use the no form of this command.
Syntax
dot1x max-req
no dot1x max-req
count — Number of times that the switch sends an EAP-request/identity frame before
•
restarting the authentication process. (Range: 1–10)
Default Configuration
The default value for the
Command Mode
Interface Configuration (Ethernet) mode
528
802.1X Commands
count
count
parameter is 2.