Dell PowerConnect 8024 Cli Reference Manual page 927

Syntax
source-url destination-url
copy
//username
sftp|scp: @
source-url — The location URL or reserved keyword of the source file being copied. (Range:
•
1–160 characters.)
• destination-url — The URL or reserved keyword of the destination file. (Range: 1–160
characters.)
ipaddr — The IPv4 or IPv6 address of the server.
•
hostname — Hostname of the server. (Range: 1–158 characters)
•
filepath — The path to the file on the server.
•
filename — The name of the file on the server.
•
username — The user name for logging into the remote server via SSH.
•
The following table lists and describes reserved keywords.
Reserved Keyword Description
running-config Represents the current running configuration file.
startup-config Represents the startup configuration file.
startup-log Represents the startup syslog file. This can only be the source of a copy operation.
operational-log Represents the operational syslog file. This can only be the source of a copy
operation.
scriptname
script Represents a CLI script file.
image Represents the software image file. When "image" is the target of a copy
command, it refers to the backup image. When "image" is the source of a copy
command, it refers to the active image. If this is destination, the file will be
distributed to all units in the stack.
scp: Source or destination URL for an SCP network server.
sftp: Source or destination URL for an SFTP network server.
tftp: Source or destination URL for a TFTP network server. The syntax for this alias is
tftp:
described in the User Guidelines.
xmodem: Source for the file from a serial connection that uses the Xmodem protocol.
backup-config Represents the backup configuration file.
unit Indicates which unit in the stack is the target of the copy command.
Default Configuration
This command has no default configuration.
{xmodem | tftp:
ipaddr/filepath/filename
[[//location]/directory]/filename
//ipaddr/filepath/filename
hostname
| }
. An out-of-band IP address can be specifed as
Configuration and Image File Commands
|
927