Ipv6 Ospf Priority; Ipv6 Ospf Retransmit-Interval - Dell PowerConnect 8024 Cli Reference Manual

Example
The following example changes the default OSPF network type to point-to-point.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf network point-to-point

ipv6 ospf priority

Use the ipv6 ospf priority command in Interface Configuration mode to set the OSPF priority
for the specified router interface.
Syntax
priority
ipv6 ospf priority
no ipv6 ospf priority
priority — OSPF priority for specified interface. (Range: 0-255. A value of 0 indicates that the
•
router is not eligible to become the designated router on this network)
Default Configuration
1, the highest router priority, is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF priority at 50 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf priority 50

ipv6 ospf retransmit-interval

Use the ipv6 ospf retransmit-interval command in Interface Configuration mode to set the
OSPF retransmit interval for the specified interface.
Syntax
ipv6 ospf retransmit-interval
no ipv6 ospf retransmit-interval
seconds
OSPFv3 Commands
805