Permit (Management) - Dell PowerConnect 8024 Cli Reference Manual

The following example shows how to configure all the interfaces to be management interfaces
except for two interfaces, Ethernet 1/g1 and Ethernet 2/g9.
console(config)# management access-list mlist
console(config-macl)# deny ethernet 1/g1 priority <1-64>
console(config-macl)# deny ethernet 2/g9 priority <1-64>
console(config-macl)# permit priority <1-64>
console(config-macl)# exit
console(config) # management access-class mlist

permit (management)

Use the permit command in Management Access-List configuration mode to set conditions for
the management access list.
Syntax
permit ip-source
vlan-id
|port-channel
permit { ethernet
priority-value
[priority
permit service
permit priority
• ethernet
vlan-id — A valid VLAN number.
• vlan
port-channel
•
ip-address — Source IP address.
•
• mask
• mask
The prefix length must be preceded by a forward slash (/). (Range: 0–32)
• service
tftp, snmp, or sntp.
• priority
Default Configuration
This command has no default configuration.
962
Management ACL Commands
ip-address
[ mask
number
] [ service
interface-number
]
service priority-value
[priority
priority-value
interface-number — A valid routed port number.
number — A valid port channel number.
mask — Specifies the network mask of the source IP address.
prefix-length — Specifies the number of bits that comprise the source IP address prefix.
service — Indicates service type. Can be one of the following: telnet, ssh, http, https,
priority-value — Priority for the rule. (Range: 1 – 64)
mask prefix-length
| ] [ethernet
service
] [ priority
| vlan vlan-id | port-channel
]
interface-number
priority-value
]
number
} [service
| vlan
service
]