Show Classofservice Trust - Dell PowerConnect 8024 Cli Reference Manual

55
56(cs7)
57
58
59
60
61
62
63
console#

show classofservice trust

Use the show classofservice trust command in Privileged EXEC mode to display the current
trust mode setting for a specific interface.
Syntax
show classofservice trust [<
<unit>/<port-type><port> — Specifies a valid unit/port combination:
•
unit > — Physical switch identifier within the stack. Values are 1-12 .
– <
port-type > — Values are g for gigabit Ethernet port, or xg for 10 gigabit Ethernet port.
– <
port > — port number. Values are 1-24 or 1-48 for port_type g, and 1-4 for port_type xg.
– <
Example: xg2 is the 10 gigabit Ethernet port 2.
port-channel number — Specifies a valid port-channel number. Range is 1-8.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If the interface is specified, the port trust mode of the interface is displayed. If omitted, the port
trust mode for global configuration is shown.
3
3
3
3
3
3
3
3
3
unit>/<port-type><port> port-channel number
|port-channel
QoS Commands
]
421