Ipv6 Mld Snooping Maxresponse; Ipv6 Mld Snooping Mcrtexpiretime - Dell PowerConnect 8024 Cli Reference Manual

ipv6 mld snooping maxresponse

The ipv6 mld snooping maxresponse command sets the MLD Maximum Response time for an
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the MLD Query Interval time
value. The range is 1 to 3599 seconds.
Syntax
ipv6 mld snooping maxresponse [vlan-id] [seconds]
no ipv6 mld snooping maxresponse [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
• seconds — MLD maximum response time in seconds. (Range: 1–3599)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-4/g1)#ipv6 mld snooping maxresponse 33

ipv6 mld snooping mcrtexpiretime

The ipv6 mld snooping mcrtexpiretime command sets the Multicast Router Present Expiration
time. The time is set for a particular interface or VLAN. This is the amount of time in seconds
that a switch waits for a query to be received on an interface before the interface is removed
from the list of interfaces with multicast routers attached. The range is 1 to 3600 seconds.
Syntax
ipv6 mld snooping mcrtexpiretime [
no ipv6 mld snooping mcrtexpiretime [
vlan_id — Specifies a VLAN ID value in VLAN Database mode.
•
seconds — multicast router present expiration time in seconds. (Range: 1–3600)
•
vlan-id seconds
] [ ]
vlan-id
]
IPv6 MLD Snooping Commands
635