Show Ipv6 Mld-Proxy - Dell PowerConnect 8024 Cli Reference Manual

show ipv6 mld-proxy

Use the show ipv6 mld-proxy command to display a summary of the host interface status
parameters.
Syntax
show ipv6 mld-proxy
Command Mode
Privileged EXEC mode
Default Configuration
There is no default configuration for this command.
User Guidelines
The command displays the following parameters only when you enable MLD Proxy:
Interface Index
Admin Mode
Operational Mode
Version
Number of Multicast
Groups
Unsolicited Report
Interval
Querier IP Address on
Proxy Interface
Older Version 1 Querier
Timeout
Proxy Start Frequency
Example
console#show ipv6 mld-proxy
Interface Index................................ vlan 10
Admin Mode..................................... Enabled
Operational Mode............................... Enabled
686
IPv6 Routing Commands
The interface number of the MLD Proxy interface.
Indicates whether MLD Proxy is enabled or disabled. This is a configured value.
Indicates whether MLD Proxy is operationally enabled or disabled. This is a
status parameter.
The present MLD host version that is operational on the proxy interface.
The number of multicast groups that are associated with the MLD-Proxy
interface.
The time interval at which the MLD-Proxy interface sends unsolicited group
membership reports.
The IP address of the Querier, if any, in the network attached to the upstream
interface (MLD-Proxy interface).
The interval used to timeout the older version 1 queriers.
The number of times the MLD-Proxy has been stopped and started.