Command Mode
Interface configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to configure the PVID for g8, when the interface is in general
mode.
Console (config)# interface ethernet g8
Console (config-if)# switchport general pvid 234
switchport general ingress-filtering disable
The switchport general ingress-filtering disable interface configuration command disables port
ingress filtering. To enable ingress filtering on a port, use the no form of this command.
Syntax
switchport general ingress-filtering disable
no switchport general ingress-filtering disable
Default Configuration
Ingress filtering is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how to enables port ingress filtering on g8.
Console (config)# interface ethernet g8
Console (config-if)# switchport general ingress-filtering disable
switchport general acceptable-frame-type tagged-only
The switchport general acceptable-frame-type tagged-only interface configuration command
discards untagged frames at ingress. To enable untagged frames at ingress, use the no form of this
command.
460
VLAN Commands