Ip Route Distance - Dell PowerConnect 8024 Cli Reference Manual

preference — Specifies the preference value, a.k.a administrative distance, of an individual
•
static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For routed management traffic:
1. Router entries are checked for applicable destinations.
2. The globally assigned default-gateway is consulted.
Router entries take precedence over an assigned default-gateway.
Example
The following example identifies the
console(config)#ip route 192.168.10.10 255.255.255.0 192.168.20.1
200

ip route distance

Use the ip route distance command in Global Configuration mode to set the default distance
(preference) for static routes. Lower route preference values are preferred when determining the
best route. The ip route and ip route default commands allow optional setting of the distance
of an individual static route. The default distance is used when no distance is specified in these
commands. Changing the default distance does not update the distance of existing static
routes, even if they were assigned the original default distance. The new default distance are
applied to static routes created after invoking the ip route distance command.
Syntax
ip route distance
no ip route distance
integer — Specifies the distance (preference) of an individual static route. (Range 1-255)
•
Default Configuration
Default value of distance is 1.
620
IP Routing Commands
next-hop-ip
integer
integer
and a preference value of 200.