Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 367

ipv6-secondary-dns Excluded by default; includes RADIUS attribute 26-48,
Ipv6-Secondary-DNS
ipv6-virtual-router Excluded by default; includes RADIUS attribute 26-45,
Ipv6-Virtual-Router
l2tp-ppp-disconnect-cause Includes RADIUS attribute 26-51,
Disconnect-Cause
output-gigapkts Includes RADIUS attribute 26-36, Acct-Output-Gigapackets
output-gigawords Includes RADIUS attribute 53, Acct-Output-Gigawords
Attributes available for Access-Request, Acct-Start, Acct-Stop, Acct-On, and
Acct-Off messages:
nas-identifier Includes RADIUS attribute 32, NAS-Identifier
Attributes available for Access-Request, Acct-On, and Acct-Off messages:
acct-session-id Includes RADIUS attribute 44, Acct-Session-Id
Attributes available for Acct-Start, Acct-Stop, Acct-On, and Acct-Off messages:
event-timestamp Includes RADIUS attribute 55, Event-Timestamp
Attributes available for Acct-On and Acct-Off messages only:
acct-authentic Includes RADIUS attribute 45, Acct-Authentic
acct-delay-time Includes RADIUS attribute 41, Acct-Delay-Time
Attributes available for Acct-Off messages only:
acct-terminate-cause Includes RADIUS attribute 49, Acct-Terminate-Cause
access-request Specifies RADIUS Access-Request messages
acct-on Specifies RADIUS Acct-On messages
acct-off Specifies RADIUS Acct-Off messages
acct-start Specifies RADIUS Acct-Start messages
acct-stop Specifies RADIUS Acct-Stop messages
enable Enables attribute inclusion
disable Disables attribute inclusion; the attribute is excluded
Global Configuration
Mode
Chapter 6: R Commands
325
radius include