Oam Ais-Rdi - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

oam ais-rdi

oam ais-rdi [ alarmDownCount [ alarmClearTimeout ] ]
Syntax
no oam ais-rdi
Command introduced in JUNOSe Release 7.1.0.
Release Information
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
In ATM VC Configuration mode, configures surveillance parameters for alarm
Description
indication signal (AIS) and remote defect indication (RDI) F5 OAM fault management
cells on an ATM PVC. The oam ais-rdi command is valid only for data PVCs; you
cannot use this command for control (ILMI or signaling) PVCs. The no version restores
the default behavior, which disables F5 OAM alarm surveillance and restores the
default values for alarm down count and alarm clear timeout duration.
In ATM VC Class Configuration mode, configures alarm surveillance parameters for
AIS and RDI F5 OAM cells as part of a VC class definition that you assign to an ATM
data PVC. The no version restores the default behavior, which disables F5 OAM alarm
surveillance and restores the default values for alarm down count and alarm clear
timeout duration, in the VC class.
NOTE: To configure the alarm down count and alarm clear timeout F5 OAM
surveillance parameters, you must use the oam ais-rdi command. There is no
equivalent atm pvc command to configure these parameters.
Options
ATM VC Configuration, ATM VC Class Configuration
Mode
108
oam ais-rdi
alarmDownCount Number of successive alarm cells, in the range 1–60, for the
router to receive before reporting that a PVC is down; default value is 1
alarmClearTimeout Number of seconds, in the range 3–60, for the router to
wait before reporting that a PVC is up after the PVC has stopped receiving alarm
cells; default value is 3