Neighbor Site-Of-Origin - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor site-of-origin

neighbor { ipAddress | ipv6Address | peerGroupName } site-of-origin siteOfOrigin
Syntax
no neighbor { ipAddress | ipv6Address | peerGroupName } site-of-origin
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Specifies a site of origin that is added to the extended communities list in each route
Description
received from the specified peer, unless the extended communities list already
includes a site of origin. When routes are advertised to the peer, routes whose
extended communities list contain this site of origin are filtered out and not advertised
to the peer. The no version removes the site of origin for the peer.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command. You cannot override the
characteristic for a specific member of the peer group.
siteOfOrigin Designator for the site of origin; in the format AA:NN, where any
of the following is true:
AA AS number in the range 0–65535 and NN is an integer in the range
0–4294967295; for example, 320:72358
AA AS number in the range 0–4294967295 and NN is an integer in the
range 0–65535; for example, 84511:45
AA Dotted decimal IP address and NN is an integer in the range 0–65535;
for example, 10.10.21.5:1256
Chapter 2: N Commands
65
neighbor site-of-origin