Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 517

circuit-ID-only Specifies circuit ID suboption (suboption 1) only
remote-ID-only Specifies remote-ID suboption (suboption 2) only
inhibit-access-route-creation Specifies that host routes are not installed; enforces
consistent state of route/client database
In relay mode, removes all installed host routes from IP; deletes all host
routes data in the routing table and NVS; stops accumulating host route
information
In relay proxy mode, removes all installed host routes from IP; deletes all
NVS client data and stops installing host routes for newly bound clients in
IP; preserves the routing table client data and continues preservation of
newly bound clients in the routing table
discard-access-routes Removes existing access routes from the routing table
and from NVS
all Removes all existing access routes
interfaceType Interface type whose access routes should be discarded; see
Interface Types and Specifiers on page 5
interfaceSpecifier Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
unknown Removes existing host routes from unknown (nonexistent)
interfaces dynamic interfaces for which DHCP relay retains route information
after these interfaces have been deleted
Global Configuration
Mode
Chapter 7: S Commands
475
set dhcp relay