Neighbor Maximum-Prefix - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor maximum-prefix

neighbor { ipAddress | ipv6Address | peerGroupName } maximum-prefix maximum
Syntax
[ threshold ] [ strict ] [ warning-only ]
no neighbor { ipAddress | ipv6Address | peerGroupName } maximum-prefix
[ maximum ][ threshold ] [ strict ] [ warning-only ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Sets the number of prefixes that can be received from a neighbor. The no version
Description
removes the maximum prefix limitation.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of the BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
maximum Maximum number of prefixes; default value is no limit
threshold Percent of maximum at which to log a warning in the range 0–100;
default value is 75
strict Checks the maximum prefix limit against all received routes rather than
the default behavior of checking it only against accepted routes
warning-only Causes BGP software to log a warning, rather than reset the
connection if the maximum or threshold value is exceeded
Chapter 2: N Commands
neighbor maximum-prefix
47