Configuring Access Point Name Restriction (Nsm Procedure); Configuring Imsi Prefix Filter (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Related
Documentation

Configuring Access Point Name Restriction (NSM Procedure)

Related
Documentation

Configuring IMSI Prefix Filter (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
device supports the RAT, RAI, ULI, APN Restriction, and IMEI-SV in GTP attributes to
avoid treatment or categorization as unambiguous traffic, which can be harmful to GPRS
traffic or GPRS roaming traffic. These attributes are included in the set of useful filter
attributes used to block specific GPRS traffic and/or GPRS roaming traffic. When you
set an IMEI-SV IE, you must also specify an APN.
Route Types Overview on page 295
DHCP Relay Overview on page 410
Configuring Access Point Name Restriction (NSM Procedure) on page 409
To configure APN restriction:
In the NSM navigation tree, select Object Manager>GTP Objects.
1.
Select an object and click Edit.
2.
In the GTP object navigation tree, select IMSI Prefix and APN Filtering.
3.
Click New and specify the following:
4.
For APN, enter access point name mobiphone.com.mnc123.mcc456.gprs.
For Selection Mode, select Network.
Click OK to apply the settings.
Route Types Overview on page 295
3GPP R6 Information Elements Support Overview on page 407
To configure IMSI prefix filtering:
In the NSM navigation tree, select Object Manager>GTP Objects.
1.
Select an object and click Edit.
2.
In the GTP object navigation tree, select IMSI Prefix and APN Filtering.
3.
Click New and specify the following:
4.
For APN, enter access point name mobiphone.com.mnc123.mcc456.gprs.
For Selection Mode, select Mobile Station, Network, Verified.
For MCC-MNC (Mobile Country Code-Mobile Network Code), select MCC-MNC and
enter 246565.
Click OK to apply the settings.
Chapter 15: General Packet Radio Service
409