Network - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

network

For BGP:
Syntax
[ no ] network { networkNumber [ [ mask ] networkMask ] | ipv6Prefix | rtfPrefix }
[ route-map mapTag ] [ weight weight ] [ backdoor ]
For DHCP local server:
network networkAddress { networkMask | prefix }
no network [ force ]
For RIP:
[ no ] network networkAddress [ networkMask ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
rtMemNlri variable added in JUNOSe Release 9.0.0.
rtMemNlri variable replaced by rtfPrefix variable in JUNOSe Release 9.1.0.
For BGP, does one of the following:
Description
For DHCP local server, specifies IP addresses that the DHCP local server can provide
from an address pool. The no version removes the network address and mask.
For RIP, enables RIP on a specific network (not on a range of networks). If you do
not associate a network with RIP, the router cannot advertise the network in any RIP
update. The no version disables RIP on a specific network. If you do not specify a
network mask, the router applies the natural mask. Use the ip rip commands to
configure RIP attributes on the network.
Options
74
network
Configures a BGP speaker with an IPv6 or IPv4 prefix originating within its AS
that it advertises to its peers if a non-BGP route to the prefix exists in the IP
forwarding table. The no version removes the prefix.
Originates a RT-MEM-NLRI route for the prefix that represents the route-target
membership NLRI. This route is advertised to all peers that have negotiated the
route-target address family. The advertisement is used by the speaker to exhibit
interest in or request routes from a specific VPN that is not configured locally.
The no version removes the prefix.
networkNumber Prefix that BGP will advertise
networkMask Subnet mask for the network
ipv6Prefix IPv6 prefix that BGP will advertise
rtfPrefix Prefix representing the route-target membership NLRI (RT-MEM-NLRI),
in the format asNumber:extendedCommunity/prefixLength (for example,
320:320:524/36) where: