Priority Burst - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

priority burst

priority priorityValue burst burstSize
Syntax
no priority priorityValue burst
Command introduced in JUNOSe Release 8.1.0.
Release Information
Sets the burst size for each priority. The no version returns to the default value.
Description
Options
DoS Protection Group Configuration
Mode
264
priority burst
priorityValue–Hi-Green-IC, Hi-Green-SC, Hi-Yellow-IC, Hi-Yellow-SC, Lo-Green-IC,
Lo-Green-SC, Lo-Yellow-IC, Lo-Yellow-SC
burstSize Number of packets, in the range 32–65535; 0 denotes no burst size:
default value is equal to half of the configured maximum rate