Neighbor Activate - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

neighbor activate

[ no | default ] neighbor { ipAddress | ipv6Address | peerGroupName } activate
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
Specifies a peer or peer group with which routes of the current address family are
Description
exchanged. A peer or peer group can be activated in more than one address family.
By default, a peer or peer group is activated only for the IPv4 unicast address family.
The address families that are actively exchanged over a BGP session are negotiated
when the session is established. This command takes effect immediately. The no
version indicates that routes of the current address family should not be exchanged
with the peer or peer group. The default version removes the explicit configuration
from the peer or peer group and reestablishes inheritance of the feature configuration.
Options
Address Family Configuration, Router Configuration
Mode
Related Topics
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
Configuring BGP Signaling for L2VPNs and Configuring BGP Signaling for VPLS in
the JUNOSe BGP and MPLS Configuration Guide
Chapter 2: N Commands
25
neighbor activate