Pppoe Mtu - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

pppoe mtu

pppoe mtu { maximumMtu | use-lower-layer | use-mtu-tag }
Syntax
no pppoe mtu
Command introduced in JUNOSe Release 7.1.0.
Release Information
Enables you to control the deployment of larger packet sizes. The no version restores
Description
the default behavior, which specifies a maximum MTU value.
Options
Interface Configuration, Profile Configuration, Subinterface Configuration
Mode
maximumMtu Maximum transfer unit parameter in bytes, in the range 66-65535
with the default value 1494
use-lower-layer Specifies use of the lower layer interface value minus any PPPoE
overhead
use-mtu-tag Specifies use of the provided PPPoE mtu tag value
Chapter 4: P Commands
249
pppoe mtu