Route-Map - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

route-map

Specifying a route map for DVMRP or RIP:
Syntax
[ no ] route-map mapTag [ interfaceType interfaceSpecifier ]
Defining a route map:
[ no ] route-map mapTag [ permit | deny ] [ sequence ]
Defining a route map for data MDTs:
route-map routeMapName
no route-map
Command introduced before JUNOSe Release 7.1.0.
Release Information
IP PIM Data MDT Configuration mode added in JUNOSe Release 8.2.0.
Specifies a route map for DVMRP, RIP, or data MDTs, or defines the conditions for
Description
applying routing policies to filter or modify routes redistributed into or propagated
by a routing protocol. The no version deletes the route map.
Options
Address Family Configuration (RIP), Global Configuration, IP PIM Data MDT
Mode
Configuration
398
route-map
mapTag String of up to 32 alphanumeric characters.
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
mapTag String of up to 32 alphanumeric characters. The redistribute Router
Configuration command uses this string to reference this route map. Multiple
route maps may share the same map tag.
permit If the match criteria are met for this route map and permit is specified,
the route is redistributed as controlled by the set actions.
deny If the match criteria are met for the route map and deny is specified, the
route is not redistributed, and no further route maps sharing the same map tag
are examined.
sequence Number, in the range 0–65535, that indicates the position a new
route map is to have in the list of route maps already configured with the same
map tag. If given with the no version of this command, it specifies the position
of the route map that should be deleted.