Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 752

JUNOSe 11.1.x Command Reference Guide N to Z
710
show ip bgp advertised-routes
rtfPrefix Prefix representing the route-target membership NLRI (RT-MEM-NLRI),
in the format asNumber:extendedCommunity/prefixLength (for example,
320:320:524/36) where:
asNumber AS number for origin of route target information, in the range
1–4294967295
extendedCommunity Two-part number in the format number1:number2 that
identifies an extended community of VPNs, in the format number1:number2,
where:
number1 Autonomous system (AS) number, in the range
1–4294967295, or an IP address
number2 Unique integer, in the range 1–4294967295; 32 bits if number1
is a 16-bit AS number; 16 bits if number1 is an IP address or a 32-bit AS
number
prefixLength Number that specifies the length of the route prefix, in the
range 32–96
fields Displays only the specified fields; the display order of the fields is
hard-coded and not affected by the order in which you enter them
fieldOptions Fields to be displayed, in the format
all | [ afi | aggregator | as-path | atomic-aggregate | best | clusters | communities
| extended-communities | imported | intro | in-label | loc-pref | med | next-hop
| next-hop-cost | origin | originator-id | out-label | peer | peer-type | rd | safi |
stale | unknown-types | weight ]*
all All available information; not recommended, because this information
for each network does not fit on a single line and is difficult to read
afi Address family identifier
aggregator AS number and IP address of aggregator
as-path AS path through which this route bas been advertised
atomic-aggregate Whether the atomic aggregate attribute is present
best Whether this is the best route for the prefix
clusters List of cluster IDs through which the route has been advertised
communities Community number associated with the route
extended-communities Extended community
imported Whether the route was imported
intro Introductory information about the state of various BGP attributes;
this information is displayed only if you specify this keyword
in-label MPLS label for the route; the label received with incoming MPLS
frames; typically, but not always, this is the label advertised to MP-BGP peers
loc-pref Local preference for the route