Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 751

rtMemNlri variable replaced by rtfPrefix variable in JUNOSe Release 9.1.0.
Displays the routes in the Adj-RIBs-Out table of the specified peer or peer group. For
Description
peers, displays routes that have been previously advertised to the peer and the
attributes for the routes before the application of outbound policy.
For peer groups, displays routes that will be advertised to the peer group, but includes
the full set of route attributes associated with the routes after the application of
outbound policy. This command returns an error message unless you first enable
rib-out with the no neighbor rib-out disable command or the no rib-out disable
command.
ipv4 unicast Specifies the IPv4 unicast address family and routing table; the
Options
default option
ipv4 multicast Specifies the IPv4 multicast address family and routing table
vpnv4 all Specifies the IPv4 VPN address family and all IPv4 VPN routing and
forwarding instances
vpvn4 vrf vrfName Specifies the IPv4 VPN address family and only the IPv4
VPN routing and forwarding instance with the name vrfName
l2vpn all Displays information for only the L2VPN address family; the all
keyword is optional unless you specify a site ID and block offset
route-target signaling Specifies the route-target address family
ipAddress IP address of a neighbor whose routes the router has learned
ipv6Address IPv6 address of a neighbor whose routes the router has learned
peerGroupName Name of a BGP peer group
route-target-filter neighbor Displays routes actually advertised to the specified
peer group member (neighbor); which routes are advertised is determined by
the application of the route-target filter received from that neighbor to routes in
the peer group's Adj-RIBs-Out table
ipRtfNbrAddress IP address of a peer group member that has advertised
route-target membership filtering information
ipv6RtfNbrAddress IPv6 address of a peer group member that has advertised
route-target membership filtering information
network Route that best matches this IP address; if no network is specified,
displays the fields for all networks
networkMask Address mask to be applied to the network address
longer-prefixes Displays all routes with a prefix that is equal to or more specific
than the specified prefix
siteId Numerical identifier for the site; must be an unsigned 16-bit integer
greater than zero that is unique across the VPLS domain
blockOffset Integer in the range 1–65535 that identifies a block offset for which
information is displayed
Chapter 7: S Commands
show ip bgp advertised-routes
709