Nsf T3 - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

nsf t3

[ no ] nsf t3 { manual [ seconds ] | adjacency }
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the maximum amount of time, in seconds, that the restarting router waits
Description
before setting the overload bit to indicate that the LSP database has not been
synchronized and the IS-IS graceful restart operation has failed. The no version
restores the default T3 wait time, 30 seconds.
Options
Router Configuration
Mode
96
nsf t3
manual Sets the T3 wait time manually to the specified number of seconds
seconds Maximum wait time, in the range 5–120 seconds, before the restarting
router sets the overload bit; default value is 30 seconds
adjacency Specifies that the restarting router should obtain its T3 wait time
from neighboring IS-IS routers that have active adjacencies to this router. This
option sets the wait time to the minimum of the remaining times specified in
the restart TLVs contained in the hello packets that the router receives from its
neighbors.