Profile - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

profile

To assign a profile name for a remote host:
Syntax
[ no ] profile profileName
To create a profile or assign a profile to an interface:
profile [ bridgedEthernet | ip | l2tp | ppp | pppoe | vlan | any ] profileName
no profile [ bridgedEthernet | ip | l2tp | ppp | pppoe | vlan | any ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
vlan keyword added in JUNOSe Release 7.1.0.
IP Tunnel Destination Profile Configuration mode added in JUNOSe Release 8.2.0.
When used from Global Configuration mode, creates a profile. Use profiles to configure
Description
interfaces dynamically, which enables you to manage a large number of interfaces
effectively. The no version removes the profile.
When used from Interface Configuration mode and Subinterface Configuration mode,
assigns a profile to an interface. Use profiles to configure interfaces dynamically,
which enables you to manage a large number of interfaces effectively. The no version
removes the profile assigned to the interface.
When used in IP Tunnel Destination Profile Configuration mode, defines an IP profile
with parameters that are used to stack an upper IP interface over a dynamic GRE or
DVMRP tunnel. The no version removes the IP profile from the destination profile.
When used from L2TP Destination Profile Host Configuration mode, sets an attribute
of the current remote host. The no version removes the attribute from the remote
host.
Options
Global Configuration, Interface Configuration, IP Tunnel Destination Profile
Mode
Configuration, L2TP Destination Profile Host Configuration, Subinterface Configuration
bridgedEthernet Specifies a bridged Ethernet encapsulation type to which the
profile applies
ip Specifies an IP encapsulation type to which the profile applies
l2tp Specifies an L2TP encapsulation type to which the profile applies
ppp Specifies a PPP encapsulation type to which the profile applies
pppoe Specifies a PPPoE encapsulation type to which the profile applies
vlan Specifies a VLAN encapsulation type to which the profile applies
any Specifies any autoconfigured encapsulation that does not have a specific
profile assignment
profileName Profile name of up to 80 characters
Chapter 4: P Commands
273
profile