Network Area - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

network area

[ no ] network ipNet maskWildCard area { areaId | areaIdInt }
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Defines the interfaces on which OSPF runs and the area ID for those interfaces. The
Description
no version deletes OSPF interfaces, ranges, and areas.
NOTE: Before you issue this command, you must first configure one or more
interfaces with an IP address that is within the range specified by ipNet.
Create address ranges that do not overlap; you can attach only the same range of
interfaces to a single area.
Options
Router Configuration
Mode
Related Topics
76
network area
ipNet Network number
maskWildCard Wild-card mask for the network number
areaId OSPF area ID in IP address format
areaIdInt OSPF area ID as a decimal value, in the range 0–4294967295
Configuring Routing in the Core Network for VPLS in the JUNOSe BGP and MPLS
Configuration Guide