Neighbor - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

neighbor

For ANCP:
Syntax
[ no ] neighbor neighborName
For OSPF:
neighbor ipAddressOspf [ pollinterval seconds | priority number ]
no neighbor ipAddressOspf [ pollinterval | priority ]
For RIP:
[ no ] neighbor ipAddressRip
Command introduced before JUNOSe Release 7.1.0.
Release Information
For ANCP, creates an ANCP neighbor and accesses the L2C Neighbor Configuration
Description
(config-l2c-neighbor) mode. For OSPF, configures OSPF neighbors on an NBMA
network. For RIP, specifies a RIP neighbor to which the router sends unicast messages.
The no version removes the specified neighbor configuration or, by omitting the
neighbor name, all ANCP neighbor configurations (ANCP), removes the neighbor
(OSPF and RIP), or restores the default values (OSPF).
Options
Address Family Configuration (RIP), Router Configuration
Mode
24
neighbor
neighborName Name of the ANCP neighbor
ipAddressOspf IP address of the neighbor's interface; this interface must itself
be configured for the NBMA network type
number Router priority value of the neighbor in the range 1–4294967295;
default value is 0
seconds Interval in seconds at which the neighbor is polled; should be much
larger than the hello interval (per RFC 1247); in the range 0–255; default value
is 120
ipAddressRip IP address of the neighbor's interface; this interface must be
defined as a passive interface with the passive-interface command