Ppp Keepalive - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

ppp keepalive

ppp keepalive [ seconds ]
Syntax
no ppp keepalive
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies a keepalive value. The keepalive mechanism tracks the status of the
Description
connection. To restore the default of 30 seconds, enter ppp keepalive without a
value. High-density mode is automatically selected when PPP is layered over ATM,
tunnel, or PPPoE. Low-density mode is selected when PPP is layered over HDLC.
The no version disables keepalive.
Options
Interface Configuration, Profile Configuration, Subinterface Configuration
Mode
seconds Keepalive timeout period, in the range 30–64800 seconds for
high-density mode, 1–64800 seconds for POS uplink interfaces in low-density
mode, or 10–64800 seconds for all other HDLC interfaces in low-density mode;
default value is 30 seconds
Chapter 4: P Commands
223
ppp keepalive