Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 406

JUNOSe 11.1.x Command Reference Guide N to Z
Address Family Configuration, Router Configuration
Mode
364
redistribute
rip Routes sourced from RIP
static Redistributes static routes
static ip Redistributes static routes for IS-IS
ospf match Determines what type(s) of routes to redistribute from OSPF; all
OSPF routes are redistributed if you do not specify a type
internal Redistributes OSPF internal routes
external 1 Redistributes OSPF external routes of metric-type 1
external 2 Redistributes OSPF external routes of metric-type 2
absoluteValue Metric that is applied to all routes from the source protocol, in
the range 0–4294967295; in BGP this value is the MED, which defaults to the
IGP metric of the redistributed route
mapTag String of up to 32 alphanumeric characters that specifies a route map
applied to all routes from the source protocol; all routes are redistributed if you
do not specify a route map
wtValue Administrative weight (relative importance) for routes redistributed
into the protocol; a number, in the range 0–65535
level-1 Specifies the redistribution of routes into only IS-IS level 1
level-1-2 Specifies the redistribution of routes into both IS-IS level 1 and level 2
level-2 Specifies the redistribution of routes into only IS-IS level 2; this is the
default behavior
metric-type Specifies the OSPF or IS-IS metric type for all routes from the source
protocol
For routes redistributed into IS-IS:
metric-type external Only the metric of the route itself is considered for
comparison
metric-type internal Both the metric of the route and the cost to the router
that advertised the route are considered for comparison; this is the IS-IS
default
For routes redistributed into OSPF:
metric-type 1 Cost of the external routes is equal to the sum of all internal
costs and the external cost
metric-type 2 Cost of the external routes is equal to the external cost alone;
this is the OSPF default
tagValue Tag that is applied to all routes from the source protocol, in the range
0–4294967295
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line