Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 439

NOTE: The relay-format keyword determines the pseudowire PW Type value that
is used in LDP protocol messages. For a complete list of pseudowire Type values,
see http://www.iana.org/assignments/pwe3-parameters.
If you do not specify the relay-format keyword in the mpls-relay or route interface
command, the pseudowire Type value is chosen based on the type of the interface.
For Ethernet interfaces, the pseudowire Type value is chosen as Ethernet (0x0005).
For VLAN interfaces, the pseudowire Type value is chosen as Ethernet Tagged Mode
(0x0004)
Interface Configuration
Mode
Configuring Ethernet/VLAN Layer 2 Services, Configuring Frame Relay Layer 2
Related Topics
Services, Configuring HDLC Layer 2 Services, Configuring Ethernet Raw Mode
Encapsulation for Martini Layer 2 Transport, and Configuring S-VLAN Tunnels for
Layer 2 Services in the JUNOSe BGP and MPLS Configuration Guide
Chapter 6: R Commands
397
route interface