Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 608

For e series broadband service routers
Table of Contents

Advertisement

JUNOSe 11.1.x Command Reference Guide N to Z
566
show bgp ipv6 advertised-routes
route-target signaling Specifies the route-target address family
l2vpn Displays information for only the L2VPN address family
all Optional keyword; has no effect
route-target-filter neighbor Displays routes actually advertised to the specified
peer group member (neighbor); which routes are advertised is determined by
the application of the route-target filter received from that neighbor to routes in
the peer group's Adj-RIBs-Out table
ipRtfNbrAddress IP address of a peer group member that has advertised
route-target membership filtering information
ipv6RtfNbrAddress IPv6 address of a peer group member that has advertised
route-target membership filtering information
fields Displays only the specified fields; the display order of the fields is
hard-coded and not affected by the order in which you enter them
fieldOptions Fields to be displayed, in the format
all | [ afi | aggregator | as-path | atomic-aggregate | best | clusters | communities
| extended-communities | imported | intro | in-label | loc-pref | med | next-hop
| next-hop-cost | origin | originator-id | out-label | peer | peer-type | rd | safi |
stale | unknown-types | weight ]*
all All available information; not recommended, because this information
for each network does not fit on a single line and is difficult to read
afi Address family identifier
aggregator AS number and IP address of aggregator
as-path AS path through which this route bas been advertised
atomic-aggregate Whether the atomic aggregate attribute is present
best Whether this is the best route for the prefix
clusters List of cluster IDs through which the route has been advertised
communities Community number associated with the route
extended-communities Extended community
imported Whether the route was imported
intro Introductory information about the state of various BGP attributes;
this information is displayed only if you specify this keyword
in-label MPLS label for the route; the label received with incoming MPLS
frames; typically, but not always, this is the label advertised to MP-BGP peers
loc-pref Local preference for the route
med Multiexit discriminator for the route
next-hop IP address of the next router that is used when forwarding a
packet to the destination network

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents