Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 60

JUNOSe 11.1.x Command Reference Guide N to Z
Table 4: Interface Types and Specifiers for E120 Router and E320 Router (continued)
18
Interface Types and Specifiers
Interface Type Description
sonet – section Section layer
layer of a
SONET/SDH
interface
tenGigabitEthernet IEEE
802.3ae
10-Gigabit
Ethernet
(GE)
interface
Interface Specifier
slot/adapter/port
slot Number of the chassis slot in the
range 0–5 (E120 router) and 0–5 or
11–16 (E320 router)
adapter Identifier for the IOA within the
chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed
in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed
in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
slot/adapter/port[.subinterface1[.subinterface2
] ]
slot Number of the chassis slot in the
range 0–5 (E120 router) and 0–5 or
11–16 (E320 router)
adapter Identifier for the IOA within the
chassis slot. 0 indicates that this a
full-height IOA.
port Port number on the IOA
The meaning of the subinterface variables
depends on the configuration context. You
can configure 10-Gigabit Ethernet interfaces
with or without VLANs.
VLANs:
subinterface1 Number of the VLAN
subinterface in the range
1–2147483647; no more than 4096
VLAN subinterfaces per 10-Gigabit
Ethernet physical port
subinterface2 When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
10-Gigabit Ethernet line module
No VLANs:
subinterface1 When using PPPoE,
the number of the PPPoE
subinterface in the range
1–2147483647; no more than
16,000 PPPoE subinterfaces per
10-Gigabit Ethernet line module
subinterface2 Not used
Example
sonet 3/0/0
tenGigabitEthernet
4/0/1.20