Neighbor Graceful-Restart Stalepaths-Time - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

neighbor graceful-restart stalepaths-time

neighbor { ipAddress | ipv6Address | peerGroupName } graceful-restart
Syntax
stalepaths-time seconds
no neighbor { ipAddress | ipv6Address | peerGroupName } graceful-restart
stalepaths-time [ seconds ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
ipv6Address variable added in JUNOSe Release 8.0.0.
For a peer or peer group, sets the time period after a peer session restart during
Description
which BGP waits for an End-of-RIB marker from the peer before flushing all stale
routes from that peer. The period is measured from when the session is detected in
a down state. The no version restores the default value, 360 seconds.
Options
Address Family Configuration, Router Configuration
Mode
42
neighbor graceful-restart stalepaths-time
ipAddress IP address of BGP neighbor
ipv6Address IPv6 address of BGP neighbor
peerGroupName Name of a BGP peer group. If you specify a BGP peer group
by using the peerGroupName argument, all the members of the peer group inherit
the characteristic configured with this command, unless it is overridden for a
specific peer.
seconds Integer in the range 1–3600; default value is 360 seconds