Table of Contents
Advertisement
Services
c. For Address, enter the IPv6 address or network that can access the device's SNMP
d. Click again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX20 device:
a. Click Interfaces.
b. For Add Interface, click .
c. For Interface, select the appropriate interface from the dropdown.
d. Click again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click Zones.
b. For Add Zone, click .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click again to allow access through additional firewall zones.
6. Type the Username used to connect to the SNMP agent.
7. Type the Password used to connect to the SNMP agent.
8. (Optional) For Port, type the port number. The default is 161.
9. (Optional) Multicast DNS (mDNS) is disabled by default. mDNS is a protocol that resolves host
names in small networks that do not have a DNS server. To enable mDNS, click Enable mDNS.
10. (Optional) Select the Authentication type, either MD5 or SHA. The default is MD5.
11. (Optional) Type the Privacy passphrase. If not set, the password, entered above, is used.
12. (Optional) Select the Privacy protocol, either DES or AES. The default is DES.
13. (Optional) Add Dynamic SNMP Properties to expose specific details about your device for
SNMP monitoring that are not included in the standard MIB. To query the runtime database to
find the device property you want to expose to SNMP, see
runtime
database.
a. Click .
b. For Property, type the device property (e.g., "system.cpu_temp" or "system.name").
c. Click again to add another dynamic SNMP property.
14. (Optional) Click Enable version 2c access to enable read-only access to SNMP version 2c.
15. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX20 User Guide
agent. Allowed values are:
A single IP address or host name.
l
A network designation in CIDRnotation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SNMP agent.
l
See
Firewall configuration
Simple Network Management Protocol (SNMP)
for information about firewall zones.
Use digidevice runtime to access the
696
Advertisement
Table of Contents
