Table of Contents
Advertisement
Firmware configuration
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Users > admin.
4. Enter a new password for the admin user.The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
Note
If the
long and must contain at least one uppercase letter, one lowercase letter, one number, and
one special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
IX20 User Guide
Primary Responder feature
Change the default password for the admin user
is enabled, the password must be at least 10 characters
48
Advertisement
Table of Contents
