Table of Contents
Advertisement
b. Use the index number, 0, to remove the device from the LAN bridge:
(config)> del network bridge lan1 device 0
(config)>
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use policy routes with hotspot
When creating policy routes for hotspots, the source address should be set to use the hotspot zone:
Web
1. Create a new routing policy. See
2. During configuration, for Source address:
a. For Type, select Zone.
b. For Zone, select hotspot.
3. Click Apply to save the configuration and apply the change.
Command line
1. Create a new routing policy. See
2. During configuration, set the source address type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
3. Set the zone to hotspot:
(config network route policy 0)> src zone hotspot
(config network route policy 0)>
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Configure a routing policy
Configure a routing policy
for instructions.
for instructions.
Hotspot
380
Advertisement
Table of Contents
