Table of Contents
Advertisement
Digi IX20 hardware reference
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a binding:
(config)> add firewall qos end
(config firewall qos 2)>
4. Set the interface to the modem interface:
(config firewall qos 2)> interface /network/interface/modem
(config firewall qos 2)>
5. Set the maximum egress bandwidth of the interface to 1:
(config firewall qos 2)> bandwidth 1
(config firewall qos 2)>
6. Create a policy:
(config firewall qos 2)> add policy end
(config firewall qos 2 policy 0)>
7. Add a rule to the policy:
(config firewall qos 2 policy 0)> add rule end
(config firewall qos 2 policy 0 rule 0)>
The default settings for the policy and rule are sufficient.
8. Save the configuration and apply the change
(config firewall qos 2 policy 0 rule 09)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
QR code definition
A QR code is printed on the label attached to the device and on the loose label included in the box
with the device components. The QR code contains information about the device.
IX20 User Guide
QRcode definition
34
Advertisement
Table of Contents
